Frame BenchBody Straightening
Frame bench straightening at PRO SERVICE (Batumi, Airport Highway 212) restores body geometry after a hard impact: we clamp the car on the frame bench and measure its control points. Then we pull the frame rails, pillars and openings back to manufacturer dimensions. Price from … GEL, takes 1-3 days not including painting.
When you need a frame bench
- Doors, hood or trunk close with effort or with uneven gaps.
- The car pulls to one side, the steering wheel is crooked after an impact.
- A frame rail, pillar, floor or front/rear panel is damaged.
- Tires wear unevenly after an accident.
A hammer only fixes the outer panel. If the structural frame has shifted, the geometry stays wrong without a bench.
How we work
- Measuring: we compare the body points with the dimensions from the manufacturer's technical documentation.
- Clamping: the car is rigidly fixed to the bench frame at the factory points.
- Pulling: with chains and pulling towers we pull the deformation in the opposite direction, checking against measurements.
- Final measurement after the work, photo of the result.
- Then — welding, part replacement, painting and wheel alignment.
Equipment: ….
Price and timing
| Scope | From, GEL | Time |
|---|---|---|
| Pulling one zone (frame rail, opening) | … | 1 day |
| Full geometry restoration | … | … |
What affects the price
- How many zones are pulled: one side, the front end, or a diagonal twist.
- How deep the impact went: chassis rail, inner fender apron, pillar, floor.
- What comes off for access: bumper, radiators, subframe, suspension parts.
- Parts that cannot be pulled back and need replacing with welding.
BeforeAfter
FAQ
How much does a frame bench cost in Batumi?
From … GEL for pulling one zone. The total depends on the number of points and whether parts need replacing. Estimate after measuring.
Can geometry be restored without a frame bench?
Outer panels, yes. The structural frame (frame rails, pillars, floor), no. Without clamping and measuring, the body springs back or twists somewhere else.
Will the car be like before the accident after the frame bench?
If the deformed metal isn't torn or creased, we bring the geometry back to the manufacturer's tolerances. If a part can't be saved, we suggest replacing it and tell you before work starts.
Do I need a wheel alignment after the frame bench?
Yes, always. Pulling changes where the suspension mounting points sit.
Can I drive the car to you?
If the wheels sit straight, nothing rubs or leaks, and lights and indicators work, yes. Drive carefully and stay off the highway. If a wheel is pushed back in the arch, or the steering wheel is far off-center driving straight, call a tow truck.
Will an inspection show the car was on a frame bench?
Pulling itself leaves few marks, but welds, replaced parts and paintwork show on inspection. We don't hide repairs.
● 06 · Contact
Send a photo — get a price
Describe what happened and attach 2–3 photos of the damage. We reply with a cost and time estimate.
- Address
- Airport Highway 212, Batumi, Georgia
- Directions
- Open in Google Maps ↗
